Hello sir, the same model and the same main, I read EEPROM from my problematic board from U13 M24128 and it's exactly 16kB, your EEPROM is 256 byte. Where you read this 256 bytes from? Whic IC? This is not EEPROM I think, do you have any other file on this model, please?
The problem with TV was continuous restarts after logo, every 10 seconds, After I tryed your NAND dump on this TV, now it's not even turning on, then I wrote original firmware and the same - it's now not even turning on.

Hello dear admin, the link is not working, could you please fix it?

Hello dear admin, the link is no working, could you fix it please? 

I have 5.93V on USB instead of 5V.
Fixed that, now it's 5.14V, changed FB resistors, 4.7k has 27k resistance.

Hello our dear admin, this link is not working, could you please fix? 
If this will take a long time could you please give me a direct link for download? I need this ASAP, client will not wait more then several hours 

I set 1k resistor, but there is no changes. Also I looked into photoes, when this TV comes to me from another master and there was no resistor in that position. But I write dump into NAND and TV was working 2 days. After that I get TV back and flashed agin, then I put USB firmware and press upgrade, after that TV is always restating. Could there be a problem with SPI or Onenand?
 That resistor is connected to pin 16 CLE, how TV could worj without it 2 days?
 Also I think SPI is not touched in this chassis during USB flash. About Onenand - I don't know.

Really, there where 2 leak solders between legs! It's working now, after 1.5 months 

hello dear admin, do you know what is the difference between BN41-01660A and this B ? Will it fit?

No, only TV N1, TV N2 was not working. But N2 is working now, after changing caps and with this SPI from your site sir "Hisence LCD32V88 main RSAG7.820.1637"  .
I tried the same with N1 - nothing changed. I also noticed that there is 0.516V on +1.2V in TV N2, and 0.044V dropoff in TV N1, in other worlds, in N1 we have very low resistance on line 1.2V and a lot of consumption and as I understand this voltage goes into CPU, because when I am heating CPU - resistance on that line goes lower, heating other components - makes no changes. So now I need to wait new CPU and try it on N1 TV.

When you turn on the TV, does the standby LED turn blue and stay blue or does it turn back to red?

 The old TV (it's still with me) and the new one exactly the same, after tunrning it on, blue led goes red-blue (4-5 times) and it stays on blue color. And even there is a reaction on panel sensor buttons, when I press something - they are going on, but no changes in terminal logs when pressing them, TV just feels when I am touching them. By the way I ordered CPU MT8222 but it will come in about 1-2 weeks, but this 2nd TV client can't wait so much. And yes, again no backlight after turning on and TV consumes 19W.